1.) On either side of the car, in front of the wheel, begin to detach
the front fender wall guard from the quarter panel. There will be two body fasteners towards the front
of the vehicle; be careful not to ruin them unless you have extras. A flathead and Phillips screwdriver with
a pair of pliers are suitable removing tools.
2.) Once un-fastened, sligthy pry open the fender wall guard and slide you hand feeling
for the marker lense.
3.) Use you finger to release the metal clip that retains the marker to the front
fasica. At the same time, push that side of the lense out of the fasica.
4.) Remove marker by sliding out remaining end that's attached to the fasica and disconnect
lense from wiring harness.
5.) Remove and install new desired bulb in bulb socket.
6.) Install new marker to wiring harness and slide in the lense into the slot opening.
7.) Gently push on the other end of marker to have the metal clip snap into place on the
fasica. Double check fit + finish and all connections.
8.) Finally, re-install fender wall guard fasteners.
9.) Repeat steps #1 - 8 on other side of vehicle; afterwards test out new marker lenses.
